BLT originaly had a kit that had a bent rod. I copied that kit and sold the original to a guy who was going to repair it. My kit used 6061 aluminum rods and the IFS bars were machined to accept heim joints in the rear. I still have my measurements of what i used for rods, but you can deviate from th...

im keeping my 89 Indy 400, just a few mods this summer-96 XCR 600 motor, widen the front end to 41inches (shocks off a 99 XC SP 600), xtra-10 out of 2000 XC SP 700, seat and tank of 99 XC SP 600, new track, lighten it up a lil as well by shaveing the tunnel and remove the unnessessary items. I have ...

18 and rocking a modded up and tricked out indy 400.

I thought it was, i put 4000 miles on the motor w/out any problems with them. Your are very close to my setup, xtra-10, w/ wide front end (41 inches). If your hooking up, they will deffinitly make a major improvment and im not saying that to sell them, its because its true. I geared mine down and it...

they pull hard from 6700-8400 and yes they are loud but not obnoxious.
With everything on my motor, i pulled 84 HP on a dyno.

studs-i will be bringing the parts to a salvage yard in the fall, now im just seeing if anyone need them now. Thanks for the welcome, i havent been on this site in like 3 monthes so i decided to try it again. leelanaumotorsports-i ran the 34mm carbs w/ 280 mains. If you have a set of VM-38s in GREAT...

I am a mechanic so everything has been well taken care of, its its junk, its not forsale. -DG twin pipes for fugi 400-500cc engines-good condition (sale pending on motor choice next year)($150) This summer i will be updating my 89 indy 400 and will be selling the parts i take off. The parts are: -Co...

ttt

I'm selling an 89 Polaris indy 400 l/c. Motor just rebuilt- 0 miles (.020 over, ported), New ignition, DG twin race pipes and silencers, Clutched and jetted for fast trail under 3000 feet. Has Polaris plastic skis w/ extended spindles, kimpex gas shocks, and 96 studs. The sled has 6800 miles on the ...

You know, i tore apart a buddys 03 pro-x 600 w/ 1200 miles on it and the eyelets were shot on the front and rear track shocks. Ryde FX seriously needs to use some better materials while producing a shock. I run FOX on mine and never have these problems.