Subscribe Today

Search found 8 matches

Return to advanced search

Wrist pin removal

I tried a propane torch and a c clamp but could barely budge the pin. I'm gonna try and get a better torch to get it a little hotter i could'nt get the pin red with the propane. I can't beleive how hard it is to this pin out.
by J_ROK
January 29th, 2006, 6:55 pm
 
Forum: Tech Talk
Topic: Wrist pin removal
Replies: 19
Views: 1553

Wrist pin removal

I'll post my results after this weekend can't work on it till then
by J_ROK
January 26th, 2006, 4:58 pm
 
Forum: Tech Talk
Topic: Wrist pin removal
Replies: 19
Views: 1553

Wrist pin removal

Thanks again
by J_ROK
January 26th, 2006, 10:16 am
 
Forum: Tech Talk
Topic: Wrist pin removal
Replies: 19
Views: 1553

Wrist pin removal

I got the sled for nothing it sat for a couple of years. It started up after a few pulls. didnt seem to respond well to the throttle so checked compression one cylinder held 96# the other 30# so decided to do a rebuild. The boots from the damaged side had a hole at the bottom of it (between carb and...
by J_ROK
January 26th, 2006, 9:47 am
 
Forum: Tech Talk
Topic: Wrist pin removal
Replies: 19
Views: 1553

Wrist pin removal

I'm having a problem removing a wrist pin from a damaged piston.Removed both jugs. The one that wasn't damaged the pin moves freely but the other one will not budge is there a special tool i could get for this? I tried a c clamp didn't work. Its still attached to cam shaft dont want to take lower un...
by J_ROK
January 25th, 2006, 9:19 am
 
Forum: Tech Talk
Topic: Wrist pin removal
Replies: 19
Views: 1553

chrome cylinder walls need resurfacing

Thanks for the reply i'll do em both
by J_ROK
January 6th, 2006, 6:22 pm
 
Forum: Tech Talk
Topic: chrome cylinder walls need resurfacing
Replies: 3
Views: 295

chrome cylinder walls need resurfacing

Also the other cylinder has 96lbs. compression should this one be replaced at the same time?
by J_ROK
January 4th, 2006, 4:54 am
 
Forum: Tech Talk
Topic: chrome cylinder walls need resurfacing
Replies: 3
Views: 295

chrome cylinder walls need resurfacing

I was given a 89 Arctic Cat Couger. It has a failed cylinder took it apart and noticed the walls in it wasnt sleeved but chromed I was wondering if anybody has ever had these bored out and an after market sleeve put in i've seen them on Dennis Kirk. got outragous price to have it rechromed or replac...
by J_ROK
January 4th, 2006, 4:49 am
 
Forum: Tech Talk
Topic: chrome cylinder walls need resurfacing
Replies: 3
Views: 295

Return to advanced search

cron