stx crank

[jake_arcticcat]

I was wondring if the crank and cases from my 340( i think ss340), are the same as a ss440. I got a s340 motor and the cylinders are close together but the stx ones have a space inbetween them. Will my 440 top end fit onto the ss340 bottom end???

[Snojet Steve]

I looked over my 340 Exciter motor (SS338) carefully when I got it, comparing it to the older 338's and the Enticer 340s. There is a gap in the cranks and I do think the 433 will bolt to them. Stroke length should be the same.

[jake_arcticcat]

thanks, does anyone know the diameter and thread of a bolt so i could make a clutch puller for a stock yammy clutch.

[AHood]

no 433 top end will fit on any 338 bottom end. or vice versa. cylinder base and stud pattern is different.

jake i will check mine next week for you. i think i have a puller that worked on my yammy clutches.